ezOutput Library - On Off Example

Hardware Required

1×Arduino UNO or Genuino UNO
1×USB 2.0 cable type A/B
1×LED
1×220 ohm resistor
1×Button
1×Breadboard
4×Jumper Wires
Please note: These are affiliate links. If you buy the components through these links, We may get a commission at no extra cost to you. We appreciate it.

About ezOutput Library

Wiring Diagram

Arduino Output Library Wiring Diagram

Image is developed using Fritzing

Arduino Code

Quick Steps

  • Install ezOutput library. See How To
  • Connect Arduino to PC via USB cable
  • Open Arduino IDE, select the right board and port
  • On Arduino IDE, Go to File Examples ezOutput 01.OnOff example
/* * Created by ArduinoGetStarted.com * * This example code is in the public domain * * Tutorial page: https://arduinogetstarted.com/tutorials/arduino-output-library * * This example turn ON/OFF led according to state of button. */ #include <ezOutput.h> // ezOutput library const int BUTTON_PIN = 7; ezOutput led(9); // create ezOutput object that attach to pin 9; void setup() { Serial.begin(9600); pinMode(BUTTON_PIN, INPUT_PULLUP); } void loop() { int buttonState = digitalRead(BUTTON_PIN); if(buttonState == HIGH) led.high(); else led.low(); Serial.println(led.getState()); }
  • Click Upload button on Arduino IDE to upload code to Arduino
  • Arduino IDE Upload Code
  • Press and release the button
  • Open Serial Monitor to see result:
  • COM6
    Send
    Autoscroll Show timestamp
    Clear output
    9600 baud  
    Newline  
  • See LED's state

Code Explanation

Read the line-by-line explanation in comment lines of source code!

Comments

If you have any questions or suggestions, please comment on our YouTube channel