ezButton Library - Single Button Debounce Example

Hardware Required

1×Arduino UNO or Genuino UNO
1×USB 2.0 cable type A/B
1×Push Button
1×(Optional) Panel-mount Push Button
1×Breadboard
1×Jumper Wires
1×(Optional) 9V Power Adapter for Arduino
1×(Recommended) Screw Terminal Block Shield for Arduino Uno
1×(Optional) Transparent Acrylic Enclosure For Arduino Uno
Please note: These are Amazon affiliate links. If you buy the components through these links, We will get a commission at no extra cost to you. We appreciate it.

About Button

About Button Library

Wiring Diagram

Arduino Button Library Wiring Diagram

This image is created using Fritzing. Click to enlarge image

Arduino Code

Quick Steps

  • Install ezButton library. See How To
  • Connect Arduino to PC via USB cable
  • Open Arduino IDE, select the right board and port
  • On Arduino IDE, Go to File Examples ezButton 03.SingleButtonDebounce example
/* * Created by ArduinoGetStarted.com * * This example code is in the public domain * * Tutorial page: https://arduinogetstarted.com/tutorials/arduino-button-library * * This example reads the state of a button with debounce and print it to Serial Monitor. */ #include <ezButton.h> ezButton button(7); // create ezButton object that attach to pin 7; void setup() { Serial.begin(9600); button.setDebounceTime(50); // set debounce time to 50 milliseconds } void loop() { button.loop(); // MUST call the loop() function first if(button.isPressed()) Serial.println("The button is pressed"); if(button.isReleased()) Serial.println("The button is released"); }
  • Click Upload button on Arduino IDE to upload code to Arduino
Arduino IDE Upload Code
  • Press the button and then release
  • See the result on Serial Monitor
COM6
Send
The button is pressed The button is released
Autoscroll Show timestamp
Clear output
9600 baud  
Newline  

Code Explanation

Read the line-by-line explanation in comment lines of source code!

The Best Arduino Starter Kit

※ OUR MESSAGES