Ads by ArduinoGetStarted.com
Mouse.click()
설명
Sends a momentary click to the computer at the location of the cursor. This is the same as pressing and immediately releasing the mouse button. Mouse.click() defaults to the left mouse button.
문법
Mouse.click()
Mouse.click(button)
매개변수
- button: which mouse button to press - char
- MOUSE_LEFT (default)
- MOUSE_RIGHT
- MOUSE_MIDDLE
반환값
- 없음
예제 코드
#include <Mouse.h>
void setup() {
pinMode(2, INPUT);
//initiate the Mouse library
Mouse.begin();
}
void loop() {
//if the button is pressed, send a left mouse click
if (digitalRead(2) == HIGH) {
Mouse.click();
}
}
※ 주의 및 경고:
When you use the Mouse.click() command, the Arduino takes over your mouse! Make sure you have control before you use the command. A pushbutton to toggle the mouse control state is effective.
더보기
- 언어 : Arduino - Mouse
- 언어 : Mouse.begin()
- 언어 : Mouse.end()
- 언어 : Mouse.isPressed()
- 언어 : Mouse.move()
- 언어 : Mouse.press()
- 언어 : Mouse.release()
※ ARDUINO BUY RECOMMENDATION
| Arduino UNO R3 | |
| Arduino Starter Kit |
Disclosure: Some links in this section are Amazon affiliate links. If you make a purchase through these links, we may earn a commission at no extra cost to you.
Additionally, some links direct to products from our own brand, DIYables.
Additionally, some links direct to products from our own brand, DIYables.