Ads by ArduinoGetStarted.com
Serial.end()
Description
Disables serial communication, allowing the RX and TX pins to be used for general input and output. To re-enable serial communication, call Serial.begin().
Syntax
Serial.end()
Parameter Values
- Serial: serial port object. See the list of available serial ports for each board on the Serial main page.
Return Values
- Nothing
※ NOTES AND WARNINGS:
Serial functions are not only used for the communication between an Arduino board and Serial Monitor of Arduino IDE but also used for the communication between:
- An Arduino board and other Arduino board
- An Arduino board and other sensors/devices
- An Arduino board and computer (any Serial software on computer)* An Arduino board and other Arduino board
- An Arduino board and other sensors/devices
- An Arduino board and computer (any Serial software on computer)
See Also
- Language : Arduino - Serial
- Language : Serial.available()
- Language : Serial.availableForWrite()
- Language : Serial.begin()
- Language : Serial.find()
- Language : Serial.findUntil()
- Language : Serial.flush()
- Language : Serial.getTimeout()
- Language : if(Serial)
- Language : Serial.parseFloat()
- Language : Serial.parseInt()
- Language : Serial.peek()
- Language : Serial.print()
- Language : Serial.println()
- Language : Serial.read()
- Language : Serial.readBytes()
- Language : Serial.readBytesUntil()
- Language : Serial.readString()
- Language : Serial.readStringUntil()
- Language : serialEvent()
- Language : Serial.setTimeout()
- Language : Serial.write()
※ ARDUINO BUY RECOMMENDATION
| Arduino UNO R3 | |
| Arduino Starter Kit |
Disclosure: Some links in this section are Amazon affiliate links. If you make a purchase through these links, we may earn a commission at no extra cost to you.
Additionally, some links direct to products from our own brand, DIYables .
Additionally, some links direct to products from our own brand, DIYables .