Ads by ArduinoGetStarted.com
Serial.flush()
Description
Waits for the transmission of outgoing serial data to complete. (Prior to Arduino 1.0, this instead removed any buffered incoming serial data.)
flush() inherits from the Stream utility class.
Syntax
Serial.flush()
Parameter Values
- Serial: serial port object. See the list of available serial ports for each board on the Serial main page.
Return Values
- Nothing
※ NOTES AND WARNINGS:
Serial functions are not only used for the communication between an Arduino board and Serial Monitor of Arduino IDE but also used for the communication between:
- An Arduino board and other Arduino board
- An Arduino board and other sensors/devices
- An Arduino board and computer (any Serial software on computer)* An Arduino board and other Arduino board
- An Arduino board and other sensors/devices
- An Arduino board and computer (any Serial software on computer)
See Also
- Language : Arduino - Serial
- Language : Serial.available()
- Language : Serial.availableForWrite()
- Language : Serial.begin()
- Language : Serial.end()
- Language : Serial.find()
- Language : Serial.findUntil()
- Language : Serial.getTimeout()
- Language : if(Serial)
- Language : Serial.parseFloat()
- Language : Serial.parseInt()
- Language : Serial.peek()
- Language : Serial.print()
- Language : Serial.println()
- Language : Serial.read()
- Language : Serial.readBytes()
- Language : Serial.readBytesUntil()
- Language : Serial.readString()
- Language : Serial.readStringUntil()
- Language : serialEvent()
- Language : Serial.setTimeout()
- Language : Serial.write()
※ ARDUINO BUY RECOMMENDATION
| Arduino UNO R3 | |
| Arduino Starter Kit |
Disclosure: Some links in this section are Amazon affiliate links. If you make a purchase through these links, we may earn a commission at no extra cost to you.
Additionally, some links direct to products from our own brand, DIYables.
Additionally, some links direct to products from our own brand, DIYables.