ezOutput Library - Single Blink Without Delay Example

Hardware Required

1×Arduino UNO or Genuino UNO
1×USB 2.0 cable type A/B
1×LED
1×220 ohm resistor
1×Breadboard
1×Jumper Wires
1×(Recommended) Screw Terminal Block Shield for Arduino Uno
1×(Recommended) Breadboard Shield For Arduino Uno
1×(Recommended) Enclosure For Arduino Uno
Please note: These are Amazon affiliate links. If you buy the components through these links, We will get a commission at no extra cost to you. We appreciate it.

About LED

About ezOutput Library

Wiring Diagram

Arduino Output Library Wiring Diagram

This image is created using Fritzing. Click to enlarge image

Arduino Code

Quick Steps

  • Install ezOutput library. See How To
  • Connect Arduino to PC via USB cable
  • Open Arduino IDE, select the right board and port
  • On Arduino IDE, Go to File Examples ezOutput 03.SingleBlinkWithoutDelay example
/* * Created by ArduinoGetStarted.com * * This example code is in the public domain * * Tutorial page: https://arduinogetstarted.com/tutorials/arduino-output-library * * This example blinks an LED without using delay() function. This is a non-blocking example */ #include <ezOutput.h> // ezOutput library ezOutput led(9); // create ezOutput object that attach to pin 9; void setup() { led.blink(500, 250); // 500 milliseconds ON, 250 milliseconds OFF } void loop() { led.loop(); // MUST call the led.loop() function in loop() }
  • Click Upload button on Arduino IDE to upload code to Arduino
Arduino IDE Upload Code
  • See LED's state

Code Explanation

Read the line-by-line explanation in comment lines of source code!

The Best Arduino Starter Kit

※ OUR MESSAGES