Ads by ArduinoGetStarted.com
ezLED Library - LED Toggle Example
This tutorial shows how to use an example of ezLED library that toggles a LED each time a button is pressed.
Hardware Required
Please note: These are Amazon affiliate links. If you buy the components through these links, We will get a commission at no extra cost to you. We appreciate it.
About LED
- Refer to Arduino - Led Blink tutorial
About ezLED Library
- Refer to Arduino - ezLED Library Reference
Wiring Diagram
This image is created using Fritzing. Click to enlarge image
Arduino Code
Quick Steps
- Install ezLED library. See How To
- Connect Arduino to PC via USB cable
- Open Arduino IDE, select the right board and port
- On Arduino IDE, Go to File Examples ezLED LEDToggle example
/*
Created by ArduinoGetStarted.com
This example code is in the public domain
Tutorial page: https://arduinogetstarted.com/library/led/example/arduino-led-toggle
This example turn ON/OFF led according to state of button.
*/
#include <ezButton.h> // ezButton library https://arduinogetstarted.com/tutorials/arduino-button-library
#include <ezLED.h> // ezLED library
ezButton button(7); // create a button object that attach to pin 7
ezLED led(3); // create a LED object that attach to pin 3
void setup() {
Serial.begin(9600);
button.setDebounceTime(50); // set debounce time to 50ms
}
void loop() {
button.loop(); // MUST call the loop() function first
led.loop(); // MUST call the loop() function first
if (button.isPressed()) {
led.toggle(); // toggle immediately
//led.toggle(1000); // toggle after 1 second
}
if (led.getOnOff() == LED_ON)
Serial.println("LED is ON");
else
Serial.println("LED is OFF");
}
- Click Upload button on Arduino IDE to upload code to Arduino
- Open Serial Monitor to see result:
COM6
LED is OFF
LED is OFF
LED is OFF
LED is OFF
LED is OFF
LED is ON
LED is ON
LED is ON
LED is ON
Autoscroll
Clear output
9600 baud
Newline
Code Explanation
Read the line-by-line explanation in comment lines of source code!